Nuts come in a variety of styles, including hex, cap, coupler, wing, turnbuckle, and lock.Ī bolt is a long piece of metal with a rounded shank for a body that is threaded in a helical (circular) fashion.

They are used as fasteners for mating bolts and are held together by the frictional combination of their threads. Nuts are usually hexagonal in shape, which makes them easy to grip from all sides. I could use an angle grinder with a Roll-Lock and gently take down the high spots.Nuts and bolts are two types of fasteners used to join two parts together.Ī nut is a small metal object with a hole in the center surrounded by spirally cut grooves known as threads. What can I do to solve this? Mill the edge of the slot? I'd have to take the table off and take it to a machine shop for that as the table will not travel far enough to mill to the ends. That includes the area where I can slide it in 1/2 way and it stops dead - there is a high spot in the casting. I can take the big nut, invert it, and place it in the throat at most locations, but where there is a high 'bump' in the casting or sometimes thickness of paint, it takes effort or will not go at all. It has some high spots and is painted with a thick coat of paint. What I noticed is the throat is not machined. Now I am a Newb, but I am convinced it is the correct nut and the one from the kit is actually too small.

The larger nut fits the headspace fine - it is the throat I have a problem with. I can almost start the T-nut in the table but half-way in it is a no-go.

But they are larger in all dimensions except the hole - throat, headspace height and width.

Been holding my vise since I bought the mill. The specs say 7/16 T-slots, so I bought one of those kits that have the 7/16' T-nuts, 3/8' studs, nuts, stepped stand-offs, and clamps. A few months ago, I bought a Weiss VM元0-D mill.

Metric t slot bolts and nuts set